Garforth Plastering for Semis and Newer Estates
Flat ceilings, skimming and repairs for Garforth homes, from older houses near Main Street to the post-war semis and newer estates off Lidgett Lane and Aberford Road.

Garforth · LS25
From mining town to commuter suburb
Garforth grew around coal mining, and a few older brick and stone houses near Main Street still date from that time. Most of the town, though, was built after the war, when estates of semis and bungalows spread out towards Lidgett Lane and Aberford Road. More recent developments have since added modern detached houses and townhouses on the edges.
That gives Garforth three broad types of interior. Older houses may have solid walls and some original plaster. Post-war semis usually have gypsum on brick or block, with plasterboard ceilings. Newer homes are mostly dry lined, with plasterboard fixed by dabs or onto timber and steel studs. Each behaves differently, and the right repair depends on which you have.
The jobs Garforth homes most often need
Artex and similar textured ceilings turn up in a great many of the town's post-war houses, often in living rooms, halls and bedrooms. We sample-test older coatings before anything is disturbed, then seal and skim over them or overboard and skim. There is no sanding or scraping. The result is a smooth, flat ceiling that takes a modern paint finish and makes the room feel lighter.
On newer estates the issues are different. Board joints can crack as a house settles in its first few years, nail and screw heads pop through, and dabbed walls sometimes sound hollow or flex. We cut out and retape cracked joints, refix loose boards and skim where needed. In older houses near Main Street, cracked and blown plaster on solid walls calls for patch repairs or replastering instead.
Arranging plastering work in Garforth
Most Garforth houses have a drive or front garden, which helps with unloading boards and mixing outside. Bungalows are straightforward to work in, as everything is on one level, though ceilings make up a large share of the job. In two-storey semis we usually do a room or a floor at a time so you can keep using the rest of the house.
We start with a visit to see the rooms and ceilings, check whether you have textured coatings, board or older plaster, and talk about timing around other trades. The written quote that follows explains what is to be done in each room. If the work is in a new-build still under the builder's cover, it is worth checking with them first.
Services
Most asked-for in Garforth

Skimming & reskimming
A thin, hard new face on walls and ceilings that are sound underneath but look tired, patched or lumpy.
See the service
Artex covering & removal
Swirls, stipples and peaks made flat again.
See the service
Patch & crack repairs
Holes left by the electrician, cracks over doorframes, knocked corners and the patch where the old boiler used to be.
See the serviceAlso in Garforth
Everything else we do
FAQs
Plastering in Garforth: questions
How do you get rid of Artex ceilings in Garforth houses?
We do not scrape or sand it off. Older textured coatings are sample-tested first. Then the ceiling is either sealed and skimmed over, or new plasterboard is fixed below it and skimmed. Both methods suit the post-war semis and bungalows common across Garforth.
Why are there cracks along the ceiling joints in my new Garforth home?
Newer Garforth houses are mostly dry lined, and as timber dries and the building settles, board joints can open up. It is usually cosmetic. We cut out the cracked joint, retape and fill it, and skim if the finish needs it, so the crack is far less likely to return.
Do you plaster bungalows as well as houses?
Yes. Bungalows are often simpler to work in, but there is more ceiling area relative to wall, so ceilings take a big share of the time. Overboarding and skimming every ceiling at once gives a consistent finish throughout.
Can my walls be skimmed if they have been painted many times?
Usually, yes. Sound painted walls are cleaned down, any flaking areas removed and a bonding coat or primer applied so the skim grips properly. Loose or hollow plaster underneath needs repairing first, or the skim will not last.